Resultado de búsqueda
Choose a saw handle that keeps wrist in a natural position in the horizontal plane. Choose saw with a handle opening of at least 12 cm (5 in.) long and 6 cm (2.5 in.) wide and slanted at a 15° angle. Check the stock being cut for nails, knots, and other objects that may damage or buckle saw. Start the cut by placing your hand beside the cut ...
osition in the horizontal plane.Choose saw with a handle opening of at least 12 cm (5 in.) long and 6 cm (2.5 in.) ide and slanted at a 15° angle.Check the stock being cut for nails, knots, and other objec. s that may damage or buckle saw.Start the cut by placing your hand beside the cut mark with your thumb up.
14 de ago. de 2024 · Figure 1: Hierarchy of Control. Some sources may use a variation of this hierarchy of controls. For example, the CSA Standard 1002-12 (R2022): Occupational health and safety – Hazard identification and elimination and risk assessment and control includes a layer called "systems that increase awareness of potential hazards".
Non-sparking tools also generate sparks, sometimes referred to as “cold sparks”. These cold sparks have a low heat level and do not ignite carbon disulfide, which has the lowest ignition point of any known substance. Therefore, while “non-sparking” tools may lower the risk of a spark, they do not eliminate the possibility of sparks.
Check the saw for proper blade rotation. Set the depth of the blade, while the saw is unplugged, and lock it at a depth so that the lowest tooth does not extend more than about 0.3 cm (1/8") beneath the wood. Keep all cords clear of cutting area. Circular saws are designed for right-hand operation; left-handed operation will demand more care to ...
A vise is an indispensable tool in the tool room or workshop. Vises are usually mounted on workbenches or similar firm supports to hold material in place. Most vises can be used for a wide variety of work. Select the most suitable vise which is strong enough for the work. Wear safety glasses or goggles, or a face shield (with safety glasses or ...
Use the correct screwdriver for the job. Always match the screwdriver to the screw head, both in terms of size and type. Choose contoured handles that fit the shank tightly, with a flange to keep the hand from slipping off the tool. Use a slot screwdriver with a blade tip width that is the same as the width of slotted screw head.
Make sure you understand instructions and are properly trained before operating a hot metal saw. Hot metal saws, often referred to as cut-off saws or chop saws, use an abrasive cut-off wheel. The machine may operate dry or wet, at low or high speed, and in either manual or automatic mode. Refer to Metalworking Machines - General for general ...
Back to top. Hold reciprocating saw with both hands. Remember sabre saws cut on the up stroke. Secure and support stock as close as possible to the cutting line to avoid vibration. Keep the base or shoe of the saw in firm contact with the stock being cut. Select the correct blade for the material being cut and allow it to cut steadily.
10 de may. de 2024 · Avoid body contact with grounded surfaces like refrigerators, pipes and radiators when using electric powered tools; this will reduce the likelihood of shock if the operator's body is grounded. Do not plug several power cords into one outlet by using single-to-multiple outlet adapters or converters ("cube taps"). Do not use light duty power cords.
